10/28/2018 · Now the car won’t run and when I turn the XL5 ESC on all it does is flash between red and green. The only way to turn it off is to unplug the battery. I went through the speed trim re-programming steps in the users manual, but when I get to the send half and program reverse the light flashes green once then goes back to the alternating red and green flashing.
12/27/2019 · If you have a 2s Lipo plug it in turn it on then hold down the power button until the light is red this disables lipo pretection mode, then plug in your NIMH…
4. The light on the ESC should flash red once, then shut off. At this point, pull and hold the transmitter trigger to full throttle. 5. The light on the ESC should flash red twice. At this point, push and hold the transmitter trigger to full reverse. DO NOT let go of full reverse. 6. The light on the ESC should turn steady or blinking green.
threshold, the XL-5 will shut down all motor output. The LED on the. speed control will slowly blink red, indicating a low-voltage shutdown. The XL-5 will stay in this mode until a fully charged battery is connected. • Fast Blinking Green: The XL-5’s LED will blink fast green if Throttle Neutral.
12/6/2016 · If you power on your Traxxas vehicle and the light on the electronic speed control blinks red or red and green , low voltage detection is likely enabled and c…
green , then solid red and then begins blinking . red (indicating the Profile numbers). 3. When the LED blinks red once, release. the EZ-Set button. 4. The LED will blink and then turn solid green (Low-Voltage Detection ACTIVE) or red (Low-Voltage Detection DISABLED). The model is ready to drive.
1/28/2008 · solid green , then solid red and then begins blinking red (indicating the Profile numbers). 3. When the light blinks red twice, release the set button. 4. The light will then turn green and the model is ready to drive. Selecting Training Mode (Profile #3: 50% Forward, 100% Brakes, 50% Reverse) 1. Connect a fully charged battery pack to the XL-5 …
With the ESC off, press and hold the EZ-Set button until the LED turns solid green, then solid red and then begins blinking red (indicating the Profile numbers). 3. When the LED blinks red once, release the EZ-Set button. 4. The LED will blink and then turn solid green (Low-Voltage Detection ACTIVE) or red (Low-Voltage Detection DISABLED).
( ESC ) and turn on your transmitter. disconnect the battery. 2) The SET button on the XL-5 turns the model on and off. 8) Always disconnect and remove batteries for storage. Press the SET button until the light turns green and then release.
2/22/2012 · if it has lvd switching on and red led is nimh mode, green led is lipo mode. I think or the otherway round. if you don’t have any manuals google, traxxas xl5 pdf Feb 17, 2012 , 04:42 PM
